Skip to content

Collect and display sensor data

Collect data from a connected sensor and display it in a graph or table.

  1. Connect the desired sensor or sensors to Chemvue.

  2. Use the Navigation Bar to switch to the table, graph, or graph and table page.

    Note

    Upon connecting your first sensor to Chemvue, the program will automatically adjust to display a specific default measurement on all pages. If you wish to display a different measurement, simply select the button containing the name of the automatically displayed measurement and choose a different entry from the list.

  3. Select the Start button to begin recording data.

  4. When you are finished collecting data, select the Stop button that replaces the Start button.

    Data in table page

    Data in graph page

Change visible run

Use the following steps to change which run is displayed on the table page or graph page.

  1. Record at least two runs of data using the above procedures.
  2. Select the name of the currently displayed run underneath the Displayed Measurement button to open a list of runs.
  3. Select the run you wish to display.
  1. Record at least two runs of data using the above procedures.
  2. On the legend, check the box next to all runs you wish to display. All selected runs will be plotted on the graph simultaneously.